THANK YOU FOR CHOOSING AIC BRAND FLEXIBLE MAGNETIC SHEETING. FOLLOWING THESE GUIDELINES WILL GIVE YOU YEARS OF TROUBLE FREE SERVICE WITH YOUR AIC FLEXIBLE MAGNETIC PURCHASE.
SURFACE PREPARATION
The vehicle's surface should be waxed a minimum of 48 hours in advance before applying AIC flexible magnetic sheeting. For new vehicles or newly painted vehicles allow approximately 90 days for the paint to cure before applying AIC flexible magnetic sheeting. Wipe the surface of the vehicle with a clean dry cloth before application and make sure that all grime, dust and dirt has been removed.
INSTALLATION
It is best to apply AIC flexible magnetic sheeting when the temperature of the magnet is near room temperature or about 68° F. Carefully align one edge of the flexible magnetic sheeting to the vehicle's surface. Allow the remainder of the sheet to apply itself to the vehicle's surface. Do not allow air pockets to form under the sheet. If AIC isn't aligned correctly, be sure to completely remove the sheeting and start over again. Do not pull or drag AIC to realign. This can damage or stretch the material.
REMOVAL
Remove AIC flexible magnetic sheeting periodically to guard against moisture and dirt buildup. On vehicles it is recommended to remove daily to ensure that the vehicle and the magnetic sheet surfaces are clean and free of roadway debris. Dirt trapped between AIC magnetic sheeting and your vehicle can damage its finish.
CLEANING
Clean AIC flexible magnetic sheeting as well as the surface to be re-applied with a mild detergent, wipe with a soft cloth and allow to dry. This helps to lengthen the life of your AIC product and protects the surface of your vehicle.
STORAGE
Store AIC flexible magnetic sheeting in a clean dry area. If rolling, roll with printed or non-magnetic side out. Store on end to avoid any flat spots. If storing flat, store on a clean, smooth, flat surface. When stacking, do not stack magnetic side to magnetic side due to the potential of wrinkling caused by improper pole alignment.
CAUTION
Avoid repainted surfaces, non-metallic body fillers and wood grain vinyl siding.
NOTE
Failure to follow the AIC clean and care guide may cause damage to the applied surface and/or the magnetic material itself. AIC cannot accept and will not be held liable for any damage caused by abuse, misuse or the failure to follow the AIC clean and care guide.
